How To Use After Color Sealer

After thoroughly rinsing apply Absolute Perfection Color Sealer from roots to ends.

How to use after color sealer. Process for 10 minutes. After shampooing massage into wet hair. Use 20 -25 solids acrylic sealers they breath better enhance the color and are easier to apply.

If you dont mind a little sheen a satin poly would be the way to go. This can be very effective but finish and color consistency can vary. DO NOT apply sealer to wet or even damp surfaces.

The Xylene will quickly open the sealer up and allow the moisture to escape causing the sealer to dry a clear color. Apply the sealer coatings very thin most sealer failures are from applying the concrete sealer too thick. I most recently used purple haze by manic panic and loved the color so much.

Choose a satin or matte finish high gloss concrete sealers show scratches and imperfections much more than low gloss sealers. I dont use the Gum or anything other that the damp dye or water. Dump the Super Sheen down the drain and get a bottle of Acrylic Resolene.

3 of 3 people found this helpful. The second is a stain that uses a chemical reaction and the resulting color is what remains. Apply Shampoo and rinse.

Leave in 1-2 minutes. Modern Stone shows how to apply and use grout Color Seal to change the color of grout lines and seal and protect at the same time. On top of that Id add a few coats of polyurethane for extra stain protection.